Luxury remote-controlled roadblock

The LZ-D-GA04 luxury remote-controlled roadblock is composed of high-performance reinforced plastic blocks and stainless steel air release hollow needles. It adopts an electromechanical integrated remote control device, which is easy to operate, safe and reliable, and can be set up at any time for mobile defense, without affecting normal road traffic. It is an indispensable advanced equipment for law enforcement departments to set up checkpoints to intercept suspected vehicles.

Usage

1. Before use, it is necessary to ensure that the battery inside the remote control box is charged for sufficient time to fully charge the battery

The voltage of the source remains between 11V-13.5V.

2. On the road section where interception tasks are required, open the right side box cover of the obstacle barrier packaging box, roll out the obstacle roll, remove the elastic hook used to fix the obstacle, lean against the side of the road, and roll towards the road surface where the vehicle is to be intercepted.

3. Connect the wiring between the remote control and the obstacle head. Insert one end of the two meter three core connecting cable into the obstacle head connection socket, and the other end into the remote control box three core connection socket.

4. Open the cover of the remote control box, turn the power switch to the built-in power supply, the power indicator light will light up, and the device will enter the working state. Pull out the left receiving antenna and raise it vertically to increase the receiving distance.

5. When the task of intercepting the suspect vehicle needs to be carried out, press the large button on the remote control, and the stainless steel hollow needle inside the obstacle block will automatically stand up. If you forcefully pass through the obstacle, the wheels will be punctured with several stainless steel broken tire hollow needles, and the tires will deflate immediately within two seconds. You cannot continue driving and can only park.

6. After the interception task is completed, press the small button at the bottom of the remote control, and the vertical stainless steel hollow needle will rotate back to its original position and enter the standby state.

7. Recycling of remote-controlled obstacle blocks: After rolling the obstacle into a circle, fix the obstacle block with an elastic hook strap, turn off the power switch of the remote control box, and place the remote control box in the middle space of the obstacle block. Hold the obstacle box with your left hand, roll the obstacle block with your right hand into the box, place the connecting cable, and fasten the box cover.

8. This remote control obstacle is also equipped with an external power connection. When the power supply voltage inside the remote control box is insufficient and cannot work properly, one end of the 15M connecting cable can be inserted into the external power connection socket of the remote control box, and the other end can be inserted into the 12V car cigarette lighter socket. Turn the power switch of the remote control box to the external power position, and the operation is the same as the above usage method.

9. Work indicator light

(1) Power indicator light - When the remote control obstacle needs to perform interception tasks, turn on the power switch inside the remote control box, and the power indicator light will be on.

(2) Voltage indicator light - When the undervoltage of the power supply in the remote control box is below 10.5V, the undervoltage indicator light will light up, and it needs to be charged at this time. The charging indicator light is on during charging, and the charging time is 8-12 hours.

(3) Charging indicator light

When connected to 220V mains power, the charging indicator light is on and charging is normal. Please turn off the power switch when charging.

(4) Red work light

When the remote control obstacle is in interception mode, the red indicator light above the remote control box lights up, the interception task is completed, the power is turned off, and the indicator light stops working.